PVD Tin coated carbide grade with good toughness and wear resistance. Good for threading and drilling (both peripheral and central inserts) on low carbon of steels, stainless steel, heat resistance steel, and cast iron.

Insert with finish ground teeth and rake surface can achieve thread operation with high precision and stable working condition

Unique wave shape chip breaker design allows the chip flows to be raised up by the chip breaker during threading and guides the chip forming along the front of chip breaker and control the chip formation in smaller curvature radius.

Image

YBG201 Coating PVD Tin coated carbide grade with good toughness and wear resistance. Good for threading and drilling (both peripheral and central inserts) on low carbon of steels, stainless steel, heat resistance steel, and cast iron. Full Profile insert The insert forms a complete threading profile including crest and are most commonly used in a high productivity threading Correct depth, bottom and top radii are formed therefore creating a stronger thread Stock does not need to be turned to the exact diameter prior to threading and no deburring is needed after threading Topping should be .0012-.0028"; let the threading tool finish the diameter Each insert can only cut one pitch and profile A full profile insert normally has a larger nose radius than a V partial profile therefore fewer passes will be required Reduce Work FlowBefore the threading operation, the part to be threaded does not need to take a finish machining pass on it because the WIPER edge design on the insert achieves desired vertex diameter on each thread's tip while maintaining good finish.Eliminate DeburringThe wiper edge on the insert produces good surface finish on the tip of each threads.  After the thread is made, it eliminates the deburring procedure.Chip Removal Control Unique wave shape chip breaker design allows the chip flows to be raised up by the chip breaker during threading and guides the chip forming along the front of chip breaker and control the chip formation in smaller curvature radius.  Finish GroundInsert with finish ground teeth and rake surface can achieve thread operation with high precision and stable working condition

JavaScript seems to be disabled in your browser. For the best experience on our site, be sure to turn on Javascript in your browser.

Before the threading operation, the part to be threaded does not need to take a finish machining pass on it because the WIPER edge design on the insert achieves desired vertex diameter on each thread's tip while maintaining good finish.

Image

Image

The wiper edge on the insert produces good surface finish on the tip of each threads.  After the thread is made, it eliminates the deburring procedure.