Face milling insert with eight cutting edges. - 7134215 - kennametal milling insert

CNGA-2 (CBN) 80° Rhombic Inserts with 2 CBN Tips for Machining Hardened Steel, Sintered Metals and High Temperature Alloys

CNGA (PCD) Negative 80° Rhombic Inserts with Negative Relief Angle and Single PCD Tip for Finishing Non-Ferrous Materials

CNMA-T/M1/WG (CBN) 80° Rhombic Inserts with a Single CBN Top Corner Tip for Machining Cast Iron, Hardened Steel and Super Alloys

CNMG/CNGG-SF Double-Sided 80° Rhombic Inserts for Super-Finishing; Controls Chip Flow at Very Low Feeds and Depths of Cut

CNGA (CBN) Negative 80° Rhombic Inserts with Negative Relief Angles and Single CBN Tip for Finishing Hardened Steel and Cast Iron

CNMX-M3/4MW Double-Sided 80° Rhombic Inserts with a High Helical Cutting Edge for High Metal Removal Rates on Stainless Steel