Our tungsten carbide inserts could to be processed Alloy steel, Tool steel, carbon steel, stainless steel, Cast iron and Titanium alloy. Working material as following:

The tungsten carbide inserts is made of superfine cemented carbide raw material, finely ground and sintered at high temperature. The overall impact resistance of the blade is strong, and the blade is not easy to collapse; The blade is coated with Balchas coating process. The blade has excellent toughness and heat resistance, and has small chemical affinity. The chip can be removed smoothly during processing without sticking to the blade, which can improve the processing efficiency and reduce the loss rate of the blade; Reasonable chip removal groove design, with high-precision peripheral grinding to make the blade sharp, continuous/intermittent cutting can be easily handled, smooth chip removal will not produce chip buildup, so that processing is more efficient​.

2.Before installing the carbide blade, the performance and purpose of the saw table must be confirmed to ensure that the cutting direction indicated by the blade arrow is consistent with the rotation direction of the saw table. It is strictly prohibited to install in the opposite direction. Wrong installation direction may cause the blade sawtooth to fall off, so as to prevent accidents.

As you were browsing something about your browser made us think you were a bot. There are a few reasons this might happen:

3.After installation, it is necessary to confirm whether the central hole of the carbide blade is firmly fixed on the flange plate of the saw table. If there is a gasket, the gasket must be sleeved; Then, gently push with your hand to confirm whether the blade rotates eccentrically.