MRMN 200-M UM25 Copy Turning Insert 2mm wide 1mm Radius Forming PVD Coated General Use in Grade UM25 (P25–M25–S15 + PVD TiAlN Coating) Performs well on Steel and Stainless, will also cut Cast Iron and High Temperature Alloys.

Image

Some scratching around on the www told me that the large fruit-like nest is actually made of paper, and the paper is manufactured by the wasps themselves. The wasps scrape wood from a tree or log, then use water and saliva to break down the fibers in the mouth to make soft paper pulp. They paste into the paper pulp into the required shape for the nest. The cellulose fibres in the wood are the equivalent of the steel reinforcement in buildings, and the saliva is the cement. The spherical structure is just the outer protective covering. Inside this are hexagonal cells where young wasps develop, one per cell. A whole lot of wasps live in a single nest in cooperation. There must also be a complex passage system so the wasps can navigate around the thousands of cells.

The nose radius of the insert has a direct effect on the surface finish of the part in turning. Turning actually forms a helical groove on the part – a thread. The depth of the groove is the roughness height. The roughness height (Rmax) is directly proportional to the square of the feed rate, and inversely proportional to the nose radius of the tool. You can actually use a quick reference nose radius chart to determine the feed rate that you must use to get a specified surface finish for any nose radius.

To improve the surface finish you can either reduce the feed rate or increase the nose radius. Halving the feed rate improves the surface finish four times (reduces the Rmax value by 75 %). Doubling the nose radius improves the surface finish twice (reduces the Rmax value by 50 %). You can use the insert nose radius chart above to quickly decide the feedrate obtainable.

Image

This nose radius chart shows the Rmax in microns for various combinations of nose radius and feed rate. These are theoretical values, and the actual finish that you get will depend on the tool wear, the quality of the machine, vibrations, etc. These values are however a good starting point.

Some wasp factsWasps do not make honey. They are however closely related to honey bees, which do make honey.Wasps are primarily predators and feed on other insects.A Wasp can sting you and then retract its stinger, and stays alive after stinging you.When a Bee stings you it cannot withdraw its stinger, loses its stinger and much of its abdomen in the process, and dies.

Strong tip which machines into steel tube effortlessly using MGEHR 2020-2 External Groove and Turn Tool. Quick and easy to change

CADEM CAPSturn CNC lathe programming software automatically determines the cutting feed rate based on the surface finish required and the tool’s nose radius.

Image