Everything You Need to Know About Carbide Drill Bits - are carbide bits better for concrete than tungsten carbide bit
Leer este artículo en español This is an easy to make little project that will really come in handy around the shop. The design for this compact compass is simple and uses common parts, but…
It probably doesn't happen often, but occasionally you might have to clamp something together that even you longest clamp won't reach. While building a new storage cabinet for my shop, I had add onto the…
In conclusion I’ll say that it definitely works, and possibly a lot better than demonstrated here if the right grinding wheel is used to get a cleaner cutting edge. Also starting with a new, unused bit will make a difference. The bits I used were worn out and used in a hammer drill, which would make the carbide more prone to breaking.
Getting dadoes cut to the exact right width is the problem, and here's the solution. Or at least the solution that I prefer. ...
The second, unfinished hole is from the SDS bit. I stopped after it was clear that it wasn’t going to finish and I believe I could have done a better job of sharpening that one. Still, it did make it more than half way through the chisel.
This blade is not ideal for sharpening carbide, as the diamond particles are a bit too large to do a good job. It’s all that I have right now and I figured it will be good enough for a quick test. Since I would like to make a circular saw sharpening jig at some time in the future, I will be getting a proper grinding wheel for that purpose, and that can be used for this as well.
Judging from the comments I have received on a few of my videos (and another from a few years ago on a forum I participated in), there is a fairly widespread misunderstanding of what oil…
One is a regular, cheap masonry bit that I’m pretty sure I’ve never used. The second is a high quality SDS bit that I cut the thickened shank off of to use in a regular drill. The SDS bit has been used many times and is very dull.
Getting dadoes cut to the exact right width is the problem, and here's the solution. Or at least the solution that I prefer. [google_ad_in_article] Given that often the stock we use (plywood, typically) is often…
This was actually a tip that I got from a comment on my “Making A Knife” video that I dismissed as something that wouldn’t work. I normally try to have a more open mind, but thought that there’s no way you could get a masonry bit sharp enough to drill into hardened steel. Well, I stand corrected and it’s a good example of how we can discount an idea based on what we think is correct, when it’s always better to take the time and try it first.
Here’s a close up of the tip after “sharpening”. Not perfect, but it didn’t have any problem drilling through the 1/4″ thick hardened steel chisel I used for the test:
Replaceable Tip Drill Inserts are a cost-effective solution for extending the life of your drill bits. These inserts are designed to easily and quickly replace worn or broken tips, allowing you to continue your drilling operations without interruption. Our inserts are available in a wide range of sizes to suit the needs of any application.
What if you are making something and you need to countersink the screws into a part that will be finished? How do you cut the countersinks cleanly and have them a perfect fit for the…
This is something I learned long ago from a TV program called "The Router Workshop" hosted by Bob Rosendahl. I don't think I was ...
I've been making and installing a lot of drawers lately as I work on my new kitchen cabinets. If you've used the standard full ext...