Learn The Milling Insert ISO Code - milling insert cross reference - milling insert cross reference

Sandvik Coromant () explained: The wiper technology for turning is based on a carefully developed series of radii that make up the cutting edge. On a conventional insert, the nose of the edge is just one radius. The wiper edge, however, is made up of a large, main radius complemented by several smaller radii. The long wiper edge should not misshape the surface nor generate unacceptable cutting forces. The wiper insert should also be as straightforward to set up and use as an ordinary insert.

Wiper inserts have changed this through the effect of their specially developed edges that smooth the scalloped tops that would otherwise have been created. An additional important feature is their improved chip-breaking capability. Wiper geometries are also designed to combine good chip control at low feeds and smooth chip breaking at high, productive feeds.

With more than 10.6 million unique visitors over the last year, Practical Machinist is the most visited site for metalworking professionals. Practical Machinist is the easiest way to learn new techniques, get answers quickly and discuss common challenges with your peers. Register for the world’s largest manufacturing technology forum for free today to stay in the know. Learn more about us.

This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.

In turning with a single-point tool, the surface finish is determined by the feedrate and nose radius, as these are in a direct relationship to the profile height of the surface (Rmax). This means that the higher the feed, the rougher the surface generated by the edge of a given nose radius.