Cutting plasticwith hot knife

STEP 4 - FINAL STEP○ Take your saw and cut an incision at one end of the panel○ Slowly start to cut the panel in a straight line directly through the panel following your lined mark precisely○ Once your panel is cut down to size it is ready to be installed as recommended

STEP 2○ Take your tape measure & pencil○ Mark out your required measurements on the back of the panel○ Make sure you make two mark's at both ends on the panel

Cutting plasticwith string

○ Pencil○ Ruler○ Tape Measure○ Your Chosen Cutting ToolOPTIONS FOR CUTTING TOOLSTenon saw or Hand SawYou can use either but please ensure the saw has a fine tooth pattern for a clean cutJigsaw A jigsaw is great for cutting curves or patterns but we do recommend a fine tooth blade Stanley Knife A sharp Stanley knife will give a perfect clean cut, please ensure you are using a stable flat surface when cuttingCircular Saw or Chop SawBoth can be used but the blade can often give a coarse/rough cut so please test first.

CUTTING A 10MM DEPTH SHOWER PANELSTEP 1 ○ Take your panel and stabilise on a flat and sturdy surface in preparation for cutting○ Flip the panel over so that the face of the panel is facing downwards