Corner RoundingEnd Mill

NOTE 1. Grades shown in above list with prefix letter E are normally made only by the basic electric furnace process. All others are normally manufactured by the basic open hearth or basic oxygen processes but may be manufactured by the basic electric furnace process with adjustments in phosphorus and sulphur.

NOTE 7. Standard alloy steels can be produced with a lead range of 0.15/0.35 percent. Lead is reported only as a range since it is added to the ladle stream as the steel is being poured.

End millCornerRadiuschart

NOTE 4. Small quantities of certain elements are present in alloy steels which are not specified or required. These elements are considered as incidental and may be present to the following maximum amounts: Copper, 0.35 percent; Nickel, 0.25 percent; Chromium, 0.20 percent and Molybdenum, 0.06 percent.

Squareend millcornerradius

Corner Radius End Mill for General Use 6mm Diameter 0.5mm Corner Radius 6mm Plain Shank 50mm Long 12mm Flute Length 4 Flutes AlTiN Coated Micro-grain Carbide.

Directory | Standard | Heat | Heat Exchanger | Temperature | Pressure | Corrosion | Hardness | Surface | Properties | Select Stainless Steel | Contact US

1008 | 1010 | 1015 | 1018 | 1020 | 1025 | 1035 | 1040 | 1045 | 1050 | 1117 | 1141 | 1144 | 12L14 | 1215 | 4140 | 4150 | 4340 | 8620 | A36 | A653 | A513 | Mechanical Properties | Physical Properties | Carbon Steel Pipe Standards | ASTM A53 B Working Pressure | ASTM A106 B Pressure Temperature Rating | Carbon Steel | Steel Alloy Designations

Fast service and good packaging. Not as sharp cutting edges as top brands but lasts for equal amount of parts in ruffing operations as five times more expensive cutters.Not quite up to finishing operations if a very high surface finish is required on same feeds and speeds as top branded equivalents. But otherwise this cutter is a great performer when cutting low carbon and stainless steel.