Root face: The length (in the primary dimension " Units " or other units ) of the material edge(s) that you do not want to chamfer.

ExternalChamfer Tool

Image

PneumaticChamfer Tool

Image

4 . (if HSS) If the material you selected is an HSS rectangular (tube) or HSS round (pipe) , a window opens that lets you set whether you want to be allowed to select the ' Outside ' or ' Inside ' or ' Both ' edges in step 5.

2 . Preselect a material to enable the Materials contextual page and click the Chamfer Edge icon found in the Operations section. Skip step 3.

Handheldchamfer Tool

5b : Press the Enter key or right-click ( Menu ) and choose " OK " on the context menu to signal to Chamfer Edge that you are done selecting edges.

Chamferingtoolfor Wood

Alternative : Invoke Chamfer Edge using the Find Tool by searching the command name and clicking the Chamfer Edge icon, which is pictured above. Proceed to step 3.

3a : Make the appropriate selections on this window and press the " OK " button on the bottom of the window. The material is regenerated with the chamfer operation removed.

2 . A Yes-No dialog box appears with the question, "Do you want to regenerate this material to clear user modified material operations?"

ChamferPlane

3a : Chamfer Edge gives you Select One Item mouse bindings and prompts you to " Select material ." This prompting also occurs if a member, bolt or weld (rather than material) was selected before invoking the command.

5 . The color of the material edges changes to the " Selectable edge " color found in User and Site Options. Locate - Pan - Menu mouse bindings become active. The status line prompts, "Locate edge(s)."

7 . Chamfer Edge shows the material edge as chamfered. The status line prompts, "Verify chamfer." Yes - No mouse bindings become active.

Chamferingtoolfor Metal

5a : Left-click ( Locate ) each of the edges you want to chamfer. As you hover an edge, it changes from the " Selectable edge " color setting to the " Selectable edge " highlighting color. Once selected, edges change to the " Primary selection surface " selection color.

Alternative 1 : Make the appropriate selections on this window, then press the " OK " button at the bottom of the window to regenerate the material.