Tungaloy Tslot cutter

SDN-XN13 Full Slot Disk Type Slotting Cutters Carrying XNMU 1306 Square Inserts with 4 Right- and 4 Left-Hand Cutting Edges

SDN-XN09 Full Slot Disk Type Slotting Cutters Carrying XNMU 0904 Square Inserts with 4 Right- and 4 Left-Hand Cutting Edges

Slotmill vs end mill

FDN-CAPM15 Full Slot Adjustable Slotting Cutters with Cartridges Carrying LNAT 1506...-PM Inserts (18.9-25.6 mm width range)

Image

FDN-XN06 Full Slot Flange Type Slotting Cutters Carrying XNMU 0603 Square Inserts with 4 Right- and 4 Left-Hand Cutting Edges

T-Slotmilling cutter

FDN-XN13 Full Slot Flange Type Slotting Cutters Carrying XNMU 1306 Square Inserts with 4 Right- and 4 Left-Hand Cutting Edges

Image

High speedmilling cutter

Long edgemilling cutter

Altintas, Y., Yellowley, I., and Tlusty, J. (August 1, 1988). "The Detection of Tool Breakage in Milling Operations." ASME. J. Eng. Ind. August 1988; 110(3): 271–277. https://doi.org/10.1115/1.3187881

FDN-XN09 Full Slot Flange Type Slotting Cutters Carrying XNMU 0904 Square Inserts with 4 Right- and 4 Left-Hand Cutting Edges

Insertcutter milling

FDN-CALN15 Full Slot Adjustable Slotting Cutters with Cartridges Carrying LN.. 1506... Inserts (18.9-25.6 mm width range)

Image

The paper describes a rather simple and efficient algorithm for processing the milling force signal to detect cutter breakage. Using sampling synchronized with cutter teeth the basic variation per tooth is removed by calculating average forces per tooth. The first difference of these forces detects both breakage and some sudden changes in cutting conditions (cornering, milling over a slot). The second difference distinguishes between the two. The algorithm is illustrated by computational simulations as well as by measurements in milling tests.

SDN-XN06 Full Slot Disk Type Slotting Cutters Carrying XNMU 0603 Square Inserts with 4 Right- and 4 Left-Hand Cutting Edges

FDN-CALN13 Full Slot Adjustable Slotting Cutters with Cartridges Carrying T490 LNHT 1306PNTR/L Inserts (17.5-23.0 mm width range)