Now you can use the button "drill-hole" (pic below) to generate the hole on the previously created point. Simply select the desired diameter and the drilling depth.

Fusion 360 threadtypes

Sketch a line with the Direction and the wanted angle of the hole you want to model from the edge on the surface she should start.

To check if the angle is right just type "i" on you Keyboard for the measurement-tool and measure the angle between your plain and the line of the sketch in "Step 1".

ExternalNPT thread Fusion 360

Here I explain how to construct holes in Fusion360 at an angle on an angled surface. If you have any questions, ideas for other tutorials or suggestions do not hesitate to contact me.

Fusion 360maleNPT thread

Now create a sketch on the level created in "Step 5". However, we do not want to draw a line now but project the leading line created in "Step 2". Click on the line you want to project and press "p" on your keyboard to project the line. Confirm with ok and the line was projected.

in this Step you have to use a plane and set it in an angle tho the sketch in "Step 2" for this you have to use the the button which you see below.

Fusion 360 NPT threadmill

Pull the plane far enough out of the part so that the hole can completely cut through the part and not just partially. Example picture is below

If you don't receive the email within an hour (and you've checked your Spam folder), email us as confirmation@grabcad.com.

The advantage of this is that when you make changes to the first sketch, they are automatically transferred without having to open and edit all the other sketches. Also if you change the thickness of the part.