Generally speaking, if the number of cutting flutes is small and the chip holding groove is large, the chip can be discharged smoothly, but at the same time, the cross-sectional area of the tool is small, the rigidity of the tool body is low, and the tool body is prone to bend in cutting.

Zip code 45235cincinnati ohio

In addition, the shorter the flute, the greater the rigidity of the tool body, and the better the cutting performance. The rigidity of the end mill is inversely proportional to the third power of the edge length.

Zip code 45235ohio

In addition to the end mill of milling steel parts, we also provide inserts for milling steel parts and turning steel parts. Welcome to consult.

The 3 flute end mill is mostly used for milling aluminum. The chip removal space is large and it is not easy to stick the cutter.

Zip code 45235map

Therefore, if the flute length (overhanging length) is doubled, the rigidity of the cutter body will be reduced to 1 / 8 of the original.

This is mainly to see the situation, 2 flute end mill chip space, the relative strength of the tool is not enough. Small and closed space is more suitable. Therefore, the keyway cutter for milling keyway is 2 fluted.

On the contrary, with the increase of the number of cutting flute and the cross-sectional area of the tool, the rigidity of the tool body will be improved, but the chip holding groove will be smaller, and the chip holding force will be reduced, which will easily lead to chip blockage and reduce the surface finish of the workpiece.

Many people wonder whether it is better to use 2 flute milling cutter or 4 flute milling cutter when milling steel parts? What’s the difference between these two kinds of end mills?