In this method drilling is done by means of rotating bits attached to lower end of hallow steel pipe. The steel pipe is attached to a square section of a steel rod at the top which is called kelly. Kelly fits in a rotating table at the surface. The rotating table is rotated by power. The powdered rock and cuttings are removed by continuous circulation of drilling fluid.

The hydraulic rotary drilling rig consists of a derrick or mast, a rotating table, a pump for injecting drilling mud, a hoist and an engine. The drill pipes are seamless steel tubings generally available in 6 m lengths. The external diameter of the pipes ranges from 6 to 12 cm.

Generally adequate size of pipe is used because well drilling requires large quantity of drilling fluid in circulation. The drilling bits attached to the lower end of the drill pipe is provided with short nozzles to direct the jets of drilling fluid down the faces of the blades ofg  drilling bit. Figure 18.8 shows schematic diagram of rotary boring method.

Established way back in 1994 by Bob Ackerman, the Tool Nut began as a purveyor of power tools to residents of Westchester County about 50 miles north of New York City. Today, our family owned and operated business serves professional tradespeople and DIYers across the country as the premier source of quality power tools. If you geek out over cool tools or use tools to make a living, you can rely on The Tool Nut to deliver a great shopping experience and the best deals #wearetoolnuts.   Preferred partners and authorized dealers for all major power tool brands including Milwaukee, Dewalt, Makita, Bosch, Festool, and hundreds of other popular tool brands.

JavaScript seems to be disabled in your browser. For the best experience on our site, be sure to turn on Javascript in your browser.

This method is generally called rotary boring method. This method can be successfully used for rock as well as unconsolidated formation. The method is therefore used for water well as well as oil well drilling. Oil wells are generally very deep and this method is well suited for them because unlike other methods the drilling rate is not dependent on the depth of the hole.

The founder of this company was Mr.P.SATHYASEELAN (Member of AKBDCA) pillared by his brother Mr.P.CHANDRAMOHAN (AKBDCA). He started this establishment in the year 1995 in Punalur, Kerala, INDIA.

Whether you are just getting started or a long-term a seasoned veteran in your field - we have the tools you need.  Access our pro tool shop now.