ERColletNutdimensions

FFQ4 D-M-06 Fast Feed Endmills with FLEXFIT Threaded Adaptation Carrying Single-Sided Square Inserts with 4 Cutting Edges

FFX4 ED-M Endmills with FLEXFIT Adaptation Carrying Small "Bone Shaped" Inserts with 4 Cutting Edges for Fast Feed Milling

ER32Colletholderdimensions

The ER Collet “diameter” refers to the diameter of the tool shank (tool-shank diameter) which the collet is designed to accommodate, which may vary from 3 mm up to 30 mm. This is the diameter of the diamond tool that you can use (tool shank diameter)

FFQ4 D-MM-06 Fast Feed Endmills with MULTI-MASTER Threaded Adaptation Carrying Single-Sided Square Inserts with 4 Cutting Edges

FF EWX-MM Fast Feed Endmills with MULTI-MASTER Threaded Connection That Mount Double-Sided Inserts with 6 Cutting Edges

ER20Collet dimensions

EB-A2 (stub cut length) 2 Flute, 30° Helix Stub Cut Length Ball Nose Solid Carbide Endmills for Materials up to 55-70 HRC

FFX4 ED-MM Endmills with MULTI-MASTER Adaptation that Mount Small "Bone Shaped" Inserts with 4 Cutting Edges for Fast Feed Milling

ERcollet DimensionsPDF

EFP-E4,5CF Solid Carbide Roughing Endmills with Chip Splitting Cutting Edges, Variable Pitch and Large Radius Front Edge

Colletsizes chart

FFQ4 D-M-09 Fast Feed Endmills with FLEXFIT Threaded Adaptation Carrying Single-Sided Square Inserts with 4 Cutting Edges

EB-A2 (precision stub cut) 2 Flute, 30° Helix Stub Cut Length High Precision Ball Nose Endmills with Relieved Necks for Materials up to 65 HRC

BCM-MM Ball Nose Endmills with MULTI-MASTER Threaded Adaptation that Mount Tangent Straight Edge Inserts for Finish Profiling

ER11Colletnutdimensions

ER40Collet dimensions

La società MMG SERVICE SRL ha ricevuto nel corso del 2020 e 2021 gli aiuti di stato pubblicati sul RNA sezione Trasparenza.

ER collet clamping systems are widely used in all machining sectors and extensively for straight-shank diamond tools. The ‘ER’ numbers are loosely associated with the diameter of the interchangeable collets, measured in millimeters.

EB-A2 (long with neck) 2 Flute, 30° Helix Long Solid Carbide Ball Nose Endmills with Relieved Necks for Materials up to 65 HRC

ER25Collet dimensions

MM ET Solid Carbide Tapered Heads with 20/30° Helix, Variable Pitch and Coolant Holes for CHATTERFREE Finishing Operations

EB-A2 (tapered flute & neck) 2 Tapered Flutes, 30° Helix Solid Carbide Ball Nose Endmills with Relieved Necks for Materials up to 65 HRC

Stone fabricators often use tools with a 6 mm or 10 mm cylindrical shank, therefore 6 mm and 10 mm diameter ER collets are those most commonly used.

EB-E4L-CF 4 Flute, 45° Helix Ball Nose Endmills with 3xD Relieved Necks and Variable Pitch for Chatter Dampening on Hard Materials