Turning speeds are adjusted to the feed rate of the mini lathe (0.004/rev.), a depth of cut of 0.040, and a tool life of 180 minutes.

Chromium Nitride (CrN) is an exceptional coating for general wear resistance. It can be applied thick (25+ microns) and even in a nano-multilayer to impart ...

The new material is best applied at higher speeds and moderate feed rates, according to the developer. The inserts retain a sharp edge longer than alternative-grade versions, relieving cutting forces and excessive heat.

TAP-DRILL CHART. RECOMMEND TAP DRILL TO USE FOR 75% DEPTH OF THREAD. To Tap This Size Screw Or Bolt: Use This Drill Bit: (Closest Fractional:) Decimal Inches.

On a shaper, broach it, EDM it, or build a cutter for it.

2024115 — A chamfer tool is used for creating a rounded edge on otherwise rough surfaces. These chamfering tools or burrs will remove sharp edges from a range of ...

Feb 23, 2019 — The trim command lets you trim away sketch geometry to the nearest intersecting sketch geometry.

“This is a breakthrough technology for machining one of the most difficult materials – titanium,” stated Bernie McConnell, EVP - Commercial. “We are proud of our R&D team for again raising the bar and delivering a new titanium turning grade that offers increased value and productivity to our customers.”

GREENLEAF CORP. recently introduced carbide insert grade G-9610, claiming it will deliver a 25% increase in material removal rate and up to 100% increase in tool life versus alternative grades when machining titanium.

Grade G-9610 inserts are available in various geometries and chipforms. Incorporating a PVD coating combined with a proprietary sub-micron substrate, G-9610 inserts improve productivity for turning titanium-based alloys. The smooth and lubricious coating is wear-resistant and chemically-stable, which helps to protect the heat-resistant substrate and allows for higher speeds and extended tool life in continuous cuts.

Determine the spindle speed for turning, milling, drilling, and reaming with these charts and cutting speed calculators.

Jul 24, 2020 — Most slitting saws are HSS but carbide saws are available for harder materials. Most hobby guys go with HSS or cobalt HSS. Noisy? Not too bad.

Shop for Irwin 15-Piece Titanium Coated HHS Metal Drill Bit Set, 1/16 In. thru 3/8 In. (1/16In.thru3/8In.) at Fred Meyer. Find quality hardware products to ...

HSS or HSS/Co (Cobalt) and cutting oil. Low RPM, keep the pressure on. Carbide-tip bits are not recommended in a hand-held drill.

For example, drill bits made from high-speed steel (HSS) are fine for soft metals, while cobalt is the best drill bit for stainless steel. But solid carbide or ...

Twist Drill Bit; Brad Point Drill Bit; Masonry Drill Bit; Rivet Drill Bit; Spade Drill Bit; Installer Drill Bit; Step Drill Bit; Auger Drill Bit ...