Image

2. Preselect a material to enable the Materials contextual page and click the Chamfer Edge icon found in the Operations section. Skip step 3.

5b: Press the Enter key or right-click (Menu) and choose OK on the context menu to signal to Chamfer Edge that you are done selecting edges.

With over 40 locations throughout the country and three fully automated distribution centers, PTSolutions is continuously expanding our product offerings, while guaranteeing responsive personal service and same-day shipping.

4. The material is regenerated per the settings on its edit window. In other words, the material operation with the delete check box checked disappears.

Alternative: Invoke Chamfer Edge using the Find Tool by searching the command name and clicking the Chamfer Edge icon, which is pictured above. Proceed to step 3.

With over 40 locations throughout the country and three fully automated distribution centers, PTSolutions is continuously expanding our product offerings, while guaranteeing responsive personal service and same-day shipping.

JavaScript seems to be disabled in your browser. For the best experience on our site, be sure to turn on Javascript in your browser.

Alternative 1: Make the appropriate selections on this window, then press the OK button at the bottom of the window to regenerate the material.

4. (if HSS) If the material you selected is an HSS rectangular (tube) or HSS round (pipe), a window opens that lets you set whether you want to be allowed to select the Outside or Inside or Both edges in step 5.

1. In the view in which you want to remove the material operation, display in solid form all members that you want to edit.

5a: Left-click (Locate) each of the edges you want to chamfer. As you hover an edge, it changes from the Selectable edge color setting to the Selectable edge highlighting color. Once selected, edges change to the Primary selection surface selection color.

3a: Chamfer Edge gives you Select One Item mouse bindings and prompts you to Select material. This prompting also occurs if a member, bolt or weld (rather than material) was selected before invoking the command.

2a: Check the Delete check box next to the operation you wish to delete. If you want to delete multiple, you can select more than one. If you wish to remove all operations, select the Delete All check box.

Alternative 1: Run the Show Material Operations tool if they are not shown. Once the material operation is shown you can select it.

Specialty tool & machineomaha ne

Image

Root face: The length (in the primary dimension Units or other units) of the material edge(s) that you do not want to chamfer.

Specialty tool & machineomaha

5. The color of the material edges changes to the Selectable edge color found in User and Site Options. Locate - Pan - Menu mouse bindings become active. The status line prompts, "Locate edge(s)."

7. Chamfer Edge shows the material edge as chamfered. The status line prompts, "Verify chamfer." Yes - No mouse bindings become active.

Note: If other pieces with the same submaterial piecemark exist in the 3D model and you selected the appropriate Options, then other materials are also regenerated as specified on the edit window.