Different versions with adapted number of teeth, cutting and axial angle and cutting edge configuration allow roughing and finishing operation. The LACH DIAMOND engineers develop PCD end mills for your specific application.

PCDend mills for aluminum

PCDdiamond tools

• Yes any branded hand, power or air tool. Used or new. Sets, kits, multiple and individual items.• We provide individual quotes for higher value items, usually worth more than £30. If you have any items below this value, we suggest submitting these for a bulk quotation. We offer you one price for all your tools.• Unfortunately we do not buy faulty or unbranded goods.• Want to sell your Snap-on chest or cabinet? We will have that from you too!• We also buy specialist tooling equipment from any trade. Prices are dependent on the market needs, so you may or may not get the price you was looking for.• Selling to us is easy and if your looking for a fast and efficient way to get some money for your unwanted tools, your in the best place.

The PCD end mill with shear cut application allows the high-precision edge processing of green ceramics, graphite, GRP and CFRP.

Harvey toolPCD

End mills with PCD cutting edges are indispensable for the processing of highly abrasive materials like GRP, CFRP,  green ceramics, graphite and non-ferrous metals. The ultra-hard cutting edges allow delamination-free cuts with the desired level of quality.

PCDBall end mill

Together with you the LACH DIAMOND engineers will find the suitable PCD end mill for your application. We look forward to hearing from you.

CBN End Mill

The end mill type SMS with two PCD cutting edges is used for the high-end processing of all non-ferrous metals, GRP and CFRP.

3 to 5 PCD cutting edges allow the roughing of components made of non-ferrous metals and plastics (GRP, CFRP, graphite, green ceramics).

Diamond End Mill

The use of PCD cutting edges with extreme shear cut is recommended for finishing sensitive composite materials like GRP, CFRP, aluminium. The ultra-hard cutting edges allow for precise edge processing and a delamination-free cut.

The positive cutting angle of the PCD end mill type SMP is suitable for the processing of sensitive and thin-walled components made of non-ferrous metals and plastics (GRP, CFRP).

Fill out our easy & simple form and upload some photos. We will then evaluate your tools and get right back to you with a quote.

If you accept our offer just send them into us. Need a mailing label? No problem, we can provide one to you at a cost of £6-£12.