1. LIP CLEARANCE (fig. 12-18). The two cutting edges or lips are comparable to chisels. To cut effectively, you must relieve the heel or that part of the point back to the cutting edge. Wh.bout this clearance, it would be impossible for the lips to cut. If there is too much clearance, the cutting edges are weakened. Too little clearance results in the drill point merely rubbing without penetration. Gradually increase lip clearance toward the center until the line across dead center stands at an angle of 120 to 135 degrees with the cutting edge (fig. 12-19).

The point angle oftwistdrillfor general purpose is

2. LENGTH AND ANGLE OF LIPS. The material to be drilled determines the proper point angle. The angles, in relation to the axis, must be the same. Fifty-nine degrees has been found satisfactory for most metals. If the angles are unequal, only one lip will cut and the hole will be oversize (fig. 12-20).

3. THE PROPER LOCATION OF THE DEAD CENTER (fig. 12-21). Equal angles but lips of different lengths results in oversize holes and the resulting "wobble" places tremendous pressures on the drill press spindle and bearings.

Drill point anglechart

The web of the drill bit increases in thickness toward the shank (fig. 12-23). When the drill bit has been shortened by repeated grindings, the web must

A combination of both faults can result in a broken drill bit, and if the drill bit is very large, permanent damage to the drilling machine. The hole produced (fig. 12-22) will be oversize and often out-of-round.