Trick tools catalogfree

Any help would be greatly appreciated otherwise I will have to try guessing and checking until I get something that works.

Trick tools catalogpdf

Here is a picture of what I am trying to do. http://imgur.com/NfLfYYY Fluid is going along the two channels in the middle. The bottom part is moving back and forth. I'm using a Polyurethane ring so I'm not too worried about shearing when it crosses that small hole I just need to make sure it seals properly when the two channels are aligned. Also pressure differential the o-ring is sealing against is close to zero (mainly being used to direct flow).

r/engineering is a forum for engineering professionals to share information, knowledge, experience related to the principles & practices of the numerous engineering disciplines. r/engineering is **NOT** for students to ask for guidance on selecting their major, or for homework / project help. Read the sidebar BEFORE posting.

Trick tools catalogrequest

Enter your email address and we'll send you our newsletters about new products and industry trends! Join the EPARTRADE community.

Trick-Tools has the largest selection of hardcore, no-compromise metal fabrication tools and equipment on the planet! We believe that long-lasting quality metal fabrication tools are not only the best value in the end, but something you can enjoy using that will help you take your metal fabrication to the next level. The equipment you see on this site is hand-picked from top manufacturers around the world with over 50 percent made in the USA! We aren't limited to offering you one tool brand, but choose the best in each category to provide options for the home shop, as well as for professional use, and we back it all up with our No-Junk Guarantee.

Hi guys does anyone have experience designing dovetail grooves for small o-rings? The guides I have found online don't seem to give recommendations bellow -004. I am using a -001 ring.