Tungsten Carbide vs. Cobalt Drill Bits - titanium vs cobalt drill bits
Backdraft fire
I have had our chip guards for over 6 months and love them. They were very easy to install and cut to fit around my vises. If you ever need to add hold downs to the table its very easy to pull up and cut them to fit. They make cleaning the machine so much easier than before, no chips stuck underneath our vises for months. I won't operate another machine without these covers.
I am very pleased with the service and the product ! I used it on a European Mill with 12 mm T-slots . It's a little tight but with some oil it installed beautiful ! I actually have to get some more as it did not cover all what I wanted to ...
Backdraft 3
Successful turning requires knowledge of many factors, workholding, materials, tooling available, and much more. The following charts, images, and information are geared toward those that are familiar with Lathes in general, but would like to know more. This is part of broader curriculum we are currently working on. The Speed and Feed chart is meant to act as a general guide, your results can and often will vary greatly from job to job. Machining is complicated, only through experience will things begin to feel easier, hopefully this helps accelerate that learning curve.
Backdraft or backdrop
We know our customers are counting on us to provide the best experience possible. Our quality standards demand that every product be as close to perfection as possible. Our goal is to elevate the manufacturing trade, and it starts with offering the best tools.
Oscar-nominated special effects ignite this tale of combative firefighting siblings searching for a deadly arsonist. The film was written by former firefighter Gregory Widen and filmed in Chicago, where real city firemen served as extras.
These t-slot covers have made cleaning our mill a breeze. They are built to last and have held up perfectly for almost two years now. We highly recommend this product for it's convenience and the time it saves!
I have these on 2 machines right now. A Haas VF6, and a Hurco with a 5 Axis head. They fit like a glove on both machines and perform as expected. Cleaning the machines is so much simpler now.