If this box is checked ( ), radiused corners as defined by the field " Radius " will be applied to the most recently located point at the time you left-click ( Locate ) to define the next point. For hatches or fills defined by drawing an area box ( step 2, alternative 1 ), " Round corners " (when checked) applies the " Radius " to all four corners.

Radius: A distance (in the primary dimension " Units " or other units ) that defines the amount of rounding that takes place when the box is checked for " Round corners ."

Example: If the box was not checked when you located corner point C, and now, before you locate corner point D, you check the box, then corner rounding will apply to corner point C at the time you left-click ( Locate ) to define point D.

If the box is not checked ( ), then sharp, pointed corners will be generated. The vertex of the corner will be where you left-click ( Locate ) to define the point.

JavaScript seems to be disabled in your browser. For the best experience on our site, be sure to turn on Javascript in your browser.