Putting a bit in a Dewalt drill is an easy task. There are several types of Dewalt drills on the market, but they all have chucks and jaws located on the front of them. The chucks will look different on battery-operated drills than on those with power cords attached. The chuck key also comes in several different sizes; heavy duty dewalt drills will require a larger size chuck key than the smaller drills.

If you need any special replacement carbide tips for lathe tools or planers and jointers with tungsten carbide material, just free to inquire us.

protection against mechanical wear The Features of ToolingBox wood and metal Cutter : 1. Suitable for cutting HDF, MDF, Solid Wood, Soft Wood etc 2. Strong and sharp cutting edge 3. Smooth planing  4. 100% virgin tungsten carbide 5. Large stock available 6. Less noise

These wood cutter greatly cut noise, reduce dust and chips, and cut down labor and material costs for your business. Also it is interchangeable replacement, makes carbide insert tooling rather than traditional straight knives installed in the cutterhead. Widely used with planer, moulder, shaper or jointer, edgebanders, etc. ToolingBox Indexable Carbide Knives Properties: 1. Wear resistance with high toughness:

Squeeze the trigger of drill and hold onto the chuck at the same time to tighten jaws onto drill bit. If you are uncomfortable with this, just tighten the jaws holding the bit by turning the chuck until it is tightened by hand.

Resulting in increased tool life, reduction in number of tool changes, reduced grinding and lower production costs. 2. Resistant to corrosion:

Also ToolingBox can produce a big selection of carbide indexable insert knives for planers and jointers. In this category, you will find many different tungsten steel inserts sets for portable machines, sorted by dimensions. Many of these woodcutter tool and blade work for several different machines, including porter cable jointer, jet jointer and powermatic jointer etc. Each set is indicated with dimensions which you should compare with the actual dimensions of your old blades.

Tighten the chuck using the chuck key if possible. Most battery operated drills will not have a chuck key to tighten the bit. The drills with cords will have a tool called a chuck key hanging from the cord. Place the little round nub of the key into any of the three holes located at the base of the chuck. The teeth of the key will interlock with the teeth of the drill chuck. Turn the key so that it tightens the jaws of the drill around the drill bit.

Suitable for different cutting heads and wood chipper machine spiral planning cutter, such as groove cutter, multi-function cutter, planing cutter and spindle moulder and so on, for cutting, grooving and rebating with a long life time.

Press the directional switch so that it is set to drill. The switch will be located on top of the drill, located right above the trigger switch, or it will be a button located closer to the engine housing of the drill.

Place the bit into the jaws of the drill. Drill bits will have different types of shafts depending on what they are made for. Make sure that when tightening the jaws that the bit shaft fits snugly against the jaws of the drill.

Turn the chuck to open the jaws of the drill to fit the drill bit. The chuck is the cylinder that opens the small jaws at the tip of the drill.

ToolingBox can offers high-quality carbide cutter inserts for easy wood tools. We produce all kind of sizes including shapes of square, round, square rounded, rounded square, rounded corners square and diamond sharped carbide inserts fitting to different application. This type of indexable carbide inserts are mainly used for handheld woodturning Lathe.